Saltar al contenido principal

Aviso: Estás editando una guía de prerrequisito. Cualquier cambio que realices afectará a todas las 7 guías que incluyen este paso.

Inglés
Japonés
Paso 4
Using a T9 Torx screwdriver, remove the two 15mm silver screws that are holding a circuit board/panel to the side of the interior metal casing. Using the same screwdriver, remove the 9mm black screw located farther to the right on the same circuit board/panel. Using the same screwdriver, remove the 9mm black screw located farther to the right on the same circuit board/panel.
  • Using a T9 Torx screwdriver, remove the two 15mm silver screws that are holding a circuit board/panel to the side of the interior metal casing.

  • Using the same screwdriver, remove the 9mm black screw located farther to the right on the same circuit board/panel.

T9トルクスドライバーを使用して、回路基板/パネルを内部の金属ケース側面に固定している、銀色の15 ㎜ネジ2本をを取り外します。

同じドライバーを使用して、同じ回路基板/パネルの右にある黒い9 ㎜のネジを取り外します。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.