Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
Resumen del Video
-
Este paso está sin traducir. Ayuda a traducirlo
-
separate rubber case from back of earpiece. you don't need to remove it completely like I did.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
rotate the back away from the case. its basically glued in place with no other fasteners
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
you will need to slowly cut through the foam to separate the wires from the battery. then use a soldering iron to desolder the old battery from the board these connections go through the entire board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
solder the new battery in and test the charging before reassembly.
-
the new battery I ordered was slightly larger but it fit with no problems. I found the wires inside this device to be fairly robust and did not have any issues with wires breaking or dislodging.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
When I re-assembled I used small amounts of gorilla glue for both the case and the rubber cover. it worked very well and has worked well since. for more details I put together a short video you can check out.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.
Un comentario
I accomplished this battery replacement. I was successful. However in my opinion, this device was not meant to have this repair done. It is a “fiddley” affair, but possible. I think it took me two hours, at my leisure. Probably better off replacing the device. Unless…. your just that type who enjoys fiddling around.