Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove the debris extractor, first begin by removing and emptying the trash bin.
-
Push down and pull out on the silver button located on the top of the Roomba in the back.
-
The trash bin should then slide out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the Roomba upside down, locate the two yellow buttons by the extractor.
-
To open the flap holding the extractos in place, pinch the two yellow buttons together towards the center and pull up on the flap at the same time
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the flap is open, grab the yellow end of the dark gray extractor and pull up slightly.
-
After lifting it up about an inch, pull it out towards one of the side wheels.
-
The extractor should slide out with ease. Repeat the same procedure for the light gray debris extractor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove the Side Wheel Assembly, start by locating 2 15mm Phillips #2 Point screws above the wheels.
-
Remove the screws and pull up on the plate surrounding the side wheels.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove 3x Phillips #0 Point Screws located behind the yellow side brush, bottom let corner of heel assembly, and on the outside of the wheel assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With all the screws removed, lift up on the side wheel assembly to remove it from the Roomba housing.
-
The other wheel can be removed and replaced the same way
-
Equipo
USF Tampa, Team S13-G5, Cagle Spring 2017 Miembro de USF Tampa, Team S13-G5, Cagle Spring 2017
USFT-CAGLE-S17S13G5
4 Miembros
4 Guías creadas
