Saltar al contenido principal

Introducción

This guide will provide instructions to replace the side brush that directs debris and contaminants towards the debris extractor to be picked up.

Partes

No se especificaron partes.

  1. Start by locating the yellow side brush on the underside of the iRobot Roomba 860 near the front of the device.
    • Start by locating the yellow side brush on the underside of the iRobot Roomba 860 near the front of the device.

  2. Using a Philips #2 Point Screwdriver, remove the screw located in the center of the brush.
    • Using a Philips #2 Point Screwdriver, remove the screw located in the center of the brush.

  3. Pull up on the side brush and it should slide off, free of the motor shaft. Remove any debris that could be preventing the side brush from spinning and/or replace the side brush.
    • Pull up on the side brush and it should slide off, free of the motor shaft.

    • Remove any debris that could be preventing the side brush from spinning and/or replace the side brush.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ryan Murphy

Miembro Desde 02/03/17

446 Reputación

4 Guías creadas

Equipo

USF Tampa, Team S13-G5, Cagle Spring 2017 Miembro de USF Tampa, Team S13-G5, Cagle Spring 2017

USFT-CAGLE-S17S13G5

4 Miembros

4 Guías creadas

What to do if the screw head is broken off? Thanks

Linda - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 10

Todo El Tiempo: 280