Introducción

This guide will show how to remove the Roomba front bumper and also the sensor attached by the red ribbon wire. You will need a Phillips Head #0 Screw driver for this repair. Make sure you work on a clean flat surface for this repair. Be sure to not misplace the small screws holding the sensor to the bumper.

Partes

No se requieren partes.

  1. Place Roomba flat on table with iRobot text upside down and closest to you.
    • Place Roomba flat on table with iRobot text upside down and closest to you.

    • Detach the clips on the bumper.

    • Flip Roomba so that the bottom side is facing up and you can access bottom screws on bumper.

  2. Using a Phillips #0 screwdriver, remove the two screws.
    • Using a Phillips #0 screwdriver, remove the two screws.

    • Once the screws are removed, the wire will detach from the bumper and sensor with very light force.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Danny Andrade

Miembro Desde 01/11/18

97 Reputación

1 Guía escrita

Equipo

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 5

Últimos 30 Días: 43

Todo El Tiempo: 57