Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

iRobot Roomba 655 Pet Series Internal Faceplate Removal

Qué necesitas

  1. iRobot Roomba 655 Pet Series Internal Faceplate Removal, Front Face Plate: paso 1, imagen 1 de 2 iRobot Roomba 655 Pet Series Internal Faceplate Removal, Front Face Plate: paso 1, imagen 2 de 2
    • Remove the dust bin by pushing on the button for the dust bin removal

    • Pull the dust bin out

  2. iRobot Roomba 655 Pet Series Internal Faceplate Removal: paso 2, imagen 1 de 2 iRobot Roomba 655 Pet Series Internal Faceplate Removal: paso 2, imagen 2 de 2
    • Pull up on the silver handle to release the top protectant plastic

    • Remove the top plastic carefully

  3. iRobot Roomba 655 Pet Series Internal Faceplate Removal, Front Bumper: paso 3, imagen 1 de 2 iRobot Roomba 655 Pet Series Internal Faceplate Removal, Front Bumper: paso 3, imagen 2 de 2
    • Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.

    • Pull the plastic bumper protector up and off of the bumper.

  4. iRobot Roomba 655 Pet Series Internal Faceplate Removal: paso 4, imagen 1 de 3 iRobot Roomba 655 Pet Series Internal Faceplate Removal: paso 4, imagen 2 de 3 iRobot Roomba 655 Pet Series Internal Faceplate Removal: paso 4, imagen 3 de 3
    • Flip the Roomba back over, so you are viewing the top.

    • Pull up on the front bumper to remove it.

    • Be careful not to pull too hard because there is wiring attached to the bumper.

    • Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.

  5. iRobot Roomba 655 Pet Series Internal Faceplate Removal, Internal Faceplate: paso 5, imagen 1 de 3 iRobot Roomba 655 Pet Series Internal Faceplate Removal, Internal Faceplate: paso 5, imagen 2 de 3 iRobot Roomba 655 Pet Series Internal Faceplate Removal, Internal Faceplate: paso 5, imagen 3 de 3
    • The outside six - 10mm screws and the inside set of four - 10mm screws are the same here, use your Phillips head #2 to remove them

    • Use your Phillips head #0 to remove the one - 7mm bottom center screw

    • Use your Phillips head #2 to remove the two - 8mm screws by the handle

    • Push down the two release points to pull the plastic piece up

    • Pull the plastic piece up

Conclusión

To reassemble your device, follow these instructions in reverse order.

Rhett

Miembro Desde 01/22/15

1,329 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 21-20, Maness Winter 2015 Miembro de Cal Poly, Team 21-20, Maness Winter 2015

CPSU-MANESS-W15S21G20

4 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 734