Saltar al contenido principal

Introducción

You will be removing the front bumper (this runs into objects and walls) from the Roomba to gain access to the control center (display) and motherboard.

Partes

No se especificaron partes.

  1. Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver. Pull the plastic bumper protector up and off of the bumper.
    • Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.

    • Pull the plastic bumper protector up and off of the bumper.

  2. Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora

    Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora
  3. Flip the Roomba back over, so you are viewing the top. Pull up on the front bumper to remove it. Be careful not to pull too hard because there is wiring attached to the bumper.
    • Flip the Roomba back over, so you are viewing the top.

    • Pull up on the front bumper to remove it.

    • Be careful not to pull too hard because there is wiring attached to the bumper.

    • Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Rhett

Miembro Desde 22/01/15

1,088 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 21-20, Maness Winter 2015 Miembro de Cal Poly, Team 21-20, Maness Winter 2015

CPSU-MANESS-W15S21G20

4 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Past 24 Hours: 1

Past 7 Days: 16

Past 30 Days: 51

Todo El Tiempo: 1,282