Repara tus cosas Comunidad Tienda

iRobot Roomba 551 Brushes Replacement

Introducción

This guide explains how to remove the brushes from your iRobot Roomba 551, either for replacement or cleaning.

Qué necesitas

  1. iRobot Roomba 551 Brushes Replacement, Side Brush: paso 1, imagen 1 de 1

    • Place your Roomba upside-down on a hard surface.

    Traducir

  2. iRobot Roomba 551 Brushes Replacement: paso 2, imagen 1 de 1

    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

    Traducir

  3. iRobot Roomba 551 Brushes Replacement: paso 3, imagen 1 de 1

    • Gently pull upwards on the brush to remove it.

    Traducir

  5. iRobot Roomba 551 Brushes Replacement, Bottom Plate: paso 4, imagen 1 de 1

    • Rotate the Roomba upside-down so the bottom is facing towards you.

    Traducir

  6. iRobot Roomba 551 Brushes Replacement: paso 5, imagen 1 de 2 iRobot Roomba 551 Brushes Replacement: paso 5, imagen 2 de 2

    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

    Traducir

  7. iRobot Roomba 551 Brushes Replacement: paso 6, imagen 1 de 1

    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

    Traducir

  8. iRobot Roomba 551 Brushes Replacement, Brushes: paso 7, imagen 1 de 2 iRobot Roomba 551 Brushes Replacement, Brushes: paso 7, imagen 2 de 2

    • Pinch the yellow tabs on the sides of the brush cage and lift up to open.

    Traducir

  9. iRobot Roomba 551 Brushes Replacement: paso 8, imagen 1 de 3 iRobot Roomba 551 Brushes Replacement: paso 8, imagen 2 de 3 iRobot Roomba 551 Brushes Replacement: paso 8, imagen 3 de 3

    • Grab each brush and lift upwards to remove.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 5 otros colaboradores

John McTigue

Miembro Desde 01/31/14

331 Reputación

3 Guías creadas

Insignias: 8

+ 5 más insignias

Equipo

Cal Poly, Team 13-14, Regan Winter 2014 Miembro de Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 Miembros

19 Guías creadas

2 comentarios

Should be no need to remove the back plate. Just open the brush cage and lift out the brushes

Gunnar Nybraten - Contestar

I did all that, bought a new brush cage and it is still announcing error 2-clean brushes.

Christa Eads - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 11

Ultimos 7 días: 98

Ultimos 30 días: 474

Todo El Tiempo: 5,872