Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Eight Phillips screws are located underneath the stickers.
-
Carefully cut around the 8 screw holes using an X-acto knife or razor blade to reveal the screws.
-
Remove the screws with a #2 Phillips screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the device upside down, pull up to separate the bottom from the top cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the three arrows on each wheel.
-
Insert metal spudger at arrow locations to pop off the wheel covers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use blunt nose pliers to remove circlip.
-
Once clip is removed you can pull the wheel off in an outward motion.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove four #2 Phillips and lift off retainer.
-
Pull out all weights and set aside
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the blunt nose pliers, peel up the adhesive and feed the wires with adhesive through the opening.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
2 comentarios
Nice! Very helpful.
Popping the wheel covers as shown breaks the small hooks that hold the wheel cover on. You need to rotate the cover clock wise to release them. There probably is a special tool that uses the small impressions in the cover.