Saltar al contenido principal

Introducción

This guide is an internal private guide used as a prereq.

Partes

No se especificaron partes.

  1. Remove the two Phillips screws securing the power/volume controls to the rear panel.
    • Remove the two Phillips screws securing the power/volume controls to the rear panel.

  2. Use the tip of a spudger to remove the yellow kapton tape covering the power/volume control ribbon cable.
    • Use the tip of a spudger to remove the yellow kapton tape covering the power/volume control ribbon cable.

  3. Remove the two Phillips screws securing the power/volume controls to the rear panel.
    • Remove the two Phillips screws securing the power/volume controls to the rear panel.

    • Lift the power/volume controls out of the rear panel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 2,508