Introducción

Replace that faulty logic board to restore functionality to a broken iPod Shuffle.

  1. Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
    • Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.

    • Be careful when using a metal spudger, as you may scratch the outer case.

    Agregar Comentario

  2. Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
    • Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

    Agregar Comentario

    • Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.

    • Pry the rear case away from the front case.

    Agregar Comentario

    • Lift the bottom of the rear case and remove it from the rest of the iPod.

    Agregar Comentario

    • Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

    Agregar Comentario

    • Remove the single Phillips screw securing the logic board to the front case.

    Agregar Comentario

    • Peel the battery up from the front case with an iPod opening tool.

    • Remove the logic board and battery from the iPod.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Matthew Newsom

Miembro Desde 05/01/10

31,876 Reputación

67 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 10

Todo El Tiempo: 5,829