Saltar al contenido principal

iPhone 7 Speaker Assembly Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. iPhone 7 Speaker Assembly Replacement, Speaker Assembly: paso 1, imagen 1 de 1
    • Remove the Phillips screw securing the Wi-Fi diversity antenna to the rear case:

    • One 3.2 mm screw

  2. iPhone 7 Speaker Assembly Replacement: paso 2, imagen 1 de 1
    • Remove the following three Phillips screws securing the speaker to the rear case:

    • Two 1.3 mm screws

    • One 2.0 mm screw

  3. iPhone 7 Speaker Assembly Replacement: paso 3, imagen 1 de 3 iPhone 7 Speaker Assembly Replacement: paso 3, imagen 2 de 3 iPhone 7 Speaker Assembly Replacement: paso 3, imagen 3 de 3
    • Use the point of a spudger to lift the two antenna cable connectors up off of the sockets on the logic board.

  4. iPhone 7 Speaker Assembly Replacement: paso 4, imagen 1 de 2 iPhone 7 Speaker Assembly Replacement: paso 4, imagen 2 de 2
    • Use tweezers to derout the antenna cables from their bracket on the logic board.

  5. iPhone 7 Speaker Assembly Replacement: paso 5, imagen 1 de 2 iPhone 7 Speaker Assembly Replacement: paso 5, imagen 2 de 2
    • Use tweezers to remove the antenna cables from the clip on the speaker.

    • Make sure to grasp the cable near the clip in order to avoid damaging the cable.

  6. iPhone 7 Speaker Assembly Replacement: paso 6, imagen 1 de 2 iPhone 7 Speaker Assembly Replacement: paso 6, imagen 2 de 2
    • Use the tip of a spudger to slide the speaker assembly towards the logic board and off of the rear case.

  7. iPhone 7 Speaker Assembly Replacement: paso 7, imagen 1 de 1
    • Remove the speaker.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Scott Havard

Miembro Desde 06/27/16

49,633 Reputación

31 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 284