Saltar al contenido principal

Introducción

Prereq only, battery and logic board removed.

  1. Grasp the antenna connector with a pair of tweezers and carefully begin de-routing it from its channel on the speaker. Grasp the antenna connector with a pair of tweezers and carefully begin de-routing it from its channel on the speaker.
    • Grasp the antenna connector with a pair of tweezers and carefully begin de-routing it from its channel on the speaker.

  2. To fully de-route the antenna connector, you may need to gently pull back the metal clip securing it to the speaker assembly.
    • To fully de-route the antenna connector, you may need to gently pull back the metal clip securing it to the speaker assembly.

  3. Remove the following screws securing the speaker to the rear case:
    • Remove the following screws securing the speaker to the rear case:

    • One 2.3 mm Phillips #00 screw

    • One 2.8 mm Phillips #00 screw

  4. Lift and remove the speaker out of the iPhone.
    • Lift and remove the speaker out of the iPhone.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 202