Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y Herramientas

Introducción

Prereq only for logic board.

  1. Use a pair of tweezers to peel back the piece of tape covering the hidden screw securing the rear-facing camera bracket to the rear case.
    • Use a pair of tweezers to peel back the piece of tape covering the hidden screw securing the rear-facing camera bracket to the rear case.

  2. Remove the following screws securing the rear-facing camera bracket to the rear case:
    • Remove the following screws securing the rear-facing camera bracket to the rear case:

    • One 1.7 mm Phillips #00 screw

    • One 2.3 mm Phillips #00 screw

  3. Lift and remove the rear-facing camera bracket off the rear-facing camera.
    • Lift and remove the rear-facing camera bracket off the rear-facing camera.

  4. Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the logic board.
    • Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the logic board.

  5. Carefully lift and remove the rear-facing camera out of the iPhone.
    • Carefully lift and remove the rear-facing camera out of the iPhone.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 624