Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

iPhone 6 Plus Antenna Assembly Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. iPhone 6 Plus Antenna Assembly Replacement, Antenna Assembly: paso 1, imagen 1 de 1
    • Remove the following screws securing the antenna bracket to the rear case:

    • One 1.5 mm Phillips #00 screw

    • One 2.8 mm Phillips #00 screw

  2. iPhone 6 Plus Antenna Assembly Replacement: paso 2, imagen 1 de 1
    • Grasp the antenna bracket with a pair of tweezers and lift it off the iPhone.

  3. iPhone 6 Plus Antenna Assembly Replacement: paso 3, imagen 1 de 1
    • Carefully pry the antenna connector up off the logic board with a plastic opening tool.

  4. iPhone 6 Plus Antenna Assembly Replacement: paso 4, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 4, imagen 2 de 2
    • Grasp the antenna connector with a pair of tweezers and gently lift it from its retaining clip on the logic board.

  5. iPhone 6 Plus Antenna Assembly Replacement: paso 5, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 5, imagen 2 de 2
    • The two connectors may be coupled by a single adhesive tab. If this is the case, then they may detach as a pair.

    • Disconnect the power button cable and audio control cable connectors from their respective sockets on the logic board.

  6. iPhone 6 Plus Antenna Assembly Replacement: paso 6, imagen 1 de 1
    • Remove the following screws securing the top cellular antenna to the rear case:

    • One 2.8 mm Phillips #00 screw

    • Two 1.6 mm Phillips #00 screws

  7. iPhone 6 Plus Antenna Assembly Replacement: paso 7, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 7, imagen 2 de 2
    • Use a pair of tweezers to grasp and remove the top cellular antenna out of the iPhone.

    • During reassembly, make sure to place the small washer in the top left corner of the antenna assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 1,048