Qué necesitas
-
-
Utiliza un spudger para desconectar el cable plano del conector Lightning de su zócalo en la placa lógica.
-
El cable del conector Lightning está ligeramente adherido a un escudo de la placa lógica. Utiliza el extremo plano de un spudger para despegar suavemente el cable.
-
-
-
-
Manteniendo el teléfono nivelado, levanta el extremo inferior de la placa lógica lo suficiente para agarrarla con los dedos.
-
Aleja la placa lógica de la cámara trasera lo suficiente para que quede al descubierto la tapa de contacto dorada situada bajo el extremo superior de la placa.
-
Retira la tapa de contacto dorada de la publicación roscada de la caja trasera y apártala.
On reassembly, it was tricky for me to figure out where the gold clip went. It goes against the back case, upside down and holds the logic board grounding clip, mentioned in Step 34. The upper hole of the grounding clip goes into the gold one, with the opening of the gold one oriented to the right. The 1.2 mm Phillips #000 in the top side-wall, removed in Step 33, holds them both together.
-
-
-
Gira la placa lógica hacia arriba, hacia los botones de control de volumen, para dejar al descubierto el conector de la antena.
On this step, a small threaded barrel came off of the bottom of the housing, once I lifted off the logic board. Upon reassembly, it goes back in with the tiny threaded part down, into the silver piece near the rear facing camera. There is a little hole in the silver to receive it. When the logic board goes back down it matches up with a small silver hole and then secured to the rear case with the 2.7 mm standoff screw furthest to the left in the photo in Step 35. Take care not to put the barrel in upside down because it is very hard to get unscrewed once placed incorrectly.
-
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Un agradecimiento especial a estos traductores:
100%
¡ Mariana Roca nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›