Saltar al contenido principal

Introducción

If you have a problem with charging, connecting with iTunes, don't hear you in a phone call, connecting with WiFi, ringing.

In this video manual we will show you how to change / replace the iPhone 4S USB Charging Port Dock Connector Flex Cable with Mic and inner Ringer / Loud Speaker & WiFi Antenna flex.


Please SUBSCRIBE to my channel ツ

Resumen del Video

  1. If present, remove the small strip of tape covering one of the dock connector screws.
    • If present, remove the small strip of tape covering one of the dock connector screws.

  2. Use a plastic opening tool to flip up the retaining flap on the home button ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself.
    • Use a plastic opening tool to flip up the retaining flap on the home button ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

  3. Use a pair of tweezers to pull the home button ribbon cable out of its socket.
    • Use a pair of tweezers to pull the home button ribbon cable out of its socket.

    • There are tiny components on the back side of the ribbon, so be careful not to damage them upon ribbon removal.

  4. Carefully pull the rubber microphone holder out of its tube in the bottom edge of the iPhone.
    • Carefully pull the rubber microphone holder out of its tube in the bottom edge of the iPhone.

  5. Remove the two 1.3 mm Phillips screws securing the dock connector to the case of the iPhone.
    • Remove the two 1.3 mm Phillips screws securing the dock connector to the case of the iPhone.

  6. Remove the tiny rubber spacer near the dock connector.
    • Remove the tiny rubber spacer near the dock connector.

  7. Use the edge of a plastic opening tool to peel the dock connector and its cable off the black plastic case of the iPhone. If you are replacing the dock connector with a new part, make sure to transfer the rubber casing around the microphone. You can do this using a spudger.
    • Use the edge of a plastic opening tool to peel the dock connector and its cable off the black plastic case of the iPhone.

    • If you are replacing the dock connector with a new part, make sure to transfer the rubber casing around the microphone. You can do this using a spudger.

  8. Pry the dock connector away from its opening at the bottom of the iPhone. Remove the dock connector.
    • Pry the dock connector away from its opening at the bottom of the iPhone.

    • Remove the dock connector.

  9. Speaker enclosure remains.
    • Speaker enclosure remains.

Conclusión

To reassemble your device, follow these instructions in reverse order.

19 personas más completaron esta guía.

ZFix

Miembro Desde 09/12/13

167,786 Reputación

306 Guías creadas

Equipo

Master Techs Miembro de Master Techs

Community

290 Miembros

827 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 10,579