Saltar al contenido principal

Introducción

Prerequisite guide for disconnecting the battery before performing any repair.

Partes

No se especificaron partes.

  1. To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.
    • To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.

    • Remove the four 1.2 mm Phillips screws over the battery/display connector bracket.

  2. Remove the battery/display cable bracket.
    • Remove the battery/display cable bracket.

  3. When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board. Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.
    • When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board.

    • Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.

    • Bend the battery connector ribbon cable up slightly to prevent it from making contact and powering on the iPad.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

Miembro Desde 05/02/15

209,608 Reputación

178 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

140 Miembros

17,046 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 7

Todo El Tiempo: 152