Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 1.4 mm #00 Phillips screws securing the left and right speakers to the rear case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the tip of a spudger into the gap between the left speaker and the bottom left side of the rear case.
-
Pry around the bottom of the speaker, sliding it out from its recess in the rear case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once enough of the speaker is exposed, grasp it and pull it away from its recess in the rear case.
-
Remove the left speaker from the iPad.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tip of a spudger to slide the right speaker slightly toward the outside of the iPad.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the tip of a spudger into the gap between the right speaker and the bottom right corner of the case.
-
Pry the speaker out from its recess in the rear case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once enough of the speaker is exposed, grasp it and pull it away from its slot in the rear case.
-
Remove the right speaker from the iPad.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 2.8 mm Phillips #00 screws from the base of the Lightning connector.
-
