Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Prereq for removing logic board with no battery.

Partes

No se especificaron partes.

  1. Use the tip of a spudger to start peeling up the right side of the black tape covering the small metal bracket. Use tweezers to peel the tape up the rest of the way, and remove it from the bracket. Use tweezers to peel the tape up the rest of the way, and remove it from the bracket.
    • Use the tip of a spudger to start peeling up the right side of the black tape covering the small metal bracket.

    • Use tweezers to peel the tape up the rest of the way, and remove it from the bracket.

  2. Use a plastic opening tool to push the bracket slightly to the left. Use a plastic opening tool to push the bracket slightly to the left.
    • Use a plastic opening tool to push the bracket slightly to the left.

  3. Use a spudger tip to lift up the lower side of the bracket. Use a spudger tip to lift up the lower side of the bracket.
    • Use a spudger tip to lift up the lower side of the bracket.

  4. Remove the bracket with tweezers. During reassembly, hook the top edge of the plate in place first, then lower the bottom into its slots.
    • Remove the bracket with tweezers.

    • During reassembly, hook the top edge of the plate in place first, then lower the bottom into its slots.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 95