Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Prereq for removing logic board. Battery is out.

Partes

No se especificaron partes.

  1. Remove the following screws:
    • Remove the following screws:

    • One 2.5 mm Phillips #00

    • Two 1.1 mm Phillips #00

    • One 1.2 mm Phillips #00

  2. Use the flat end of a spudger to loosen the foam adhesive holding the antenna to the right speaker. Use the flat end of a spudger to loosen the foam adhesive holding the antenna to the right speaker. Use the flat end of a spudger to loosen the foam adhesive holding the antenna to the right speaker.
    • Use the flat end of a spudger to loosen the foam adhesive holding the antenna to the right speaker.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 54