Reemplazo del conector de la batería de iPad Mini CDMA

Introducción

Prerrequisito para desconectar la batería.

Qué necesitas

Paso 1 Conector de la batería

Reemplazo del conector de la batería de iPad Mini CDMA, Conector de la batería: paso 1, imagen 1 de 1

Remueve los tres tornillos Phillips #00 de 1.3 mm que aseguran la protección del conector a la tarjeta lógica.
Asegúrate de no sustituir estos tres tornillos con otros tornillos, específicamente con los tornillos que aseguran la placa de protección del LCD a la carcasa trasera del iPad. Cualquier tornillo por ligeramente mas largo puede remover los agujeros de los tornillos y resultar en daño irreparable dañando la tarjeta lógica.

Note: These three screws are smaller than the rest of the screws holding the larger LCD shield although they look similar. If you substitute the larger screws, you will pop a screw bracket which can damage the board on both the mini original and mini 2 retina. I just wrote a blog post about how this happens: http://mendonipadrehab.com/entries/gener...

jessabethany - 10 de jul. de 2014 Contestar

Hi jessabethany. Thank you for the warning. I read your blog post and found it to be very informative. Thanks for adding the warning to the step. It will most definitely help others avoid any damage to the logic board. Thanks!

Walter Galan - 15 de jul. de 2014

Be careful: At iPad mini retina Wi-Fi there are thw short and one longer screw! Don't mix them!

sandro - 24 de nov. de 2014 Contestar

Paso 2

Usa un par de pinzas para agarrar y remover la protección del conector del iPad.

Traducir

Paso 3

Usa una herramienta de apertura de plástico para gentilmente hacer palanca a el conector de la batería de su socket en la tarjeta lógica.
Ten cuidado de solo hacer palanca en el conector de la batería y no del mismo socket. Si haces palanca en el socket de la tarjeta lógica, puedes romper el conector por completo.

Traducir

Make sure you disconnect the battery. If not and ipad is still on you can have problems with the LCD backlight. To fix that problem you have to solder

Mattis - 6 de feb. de 2014 Contestar

I may be experiencing the backlight problem you mentioned. What connection needs to be soldered?

Grillwrecka - 11 de mar. de 2014

Have an issue - heard that if you don't disconnect the battery a fuse is blown. I need help to fix the blown fuse.

Andrew Kivell - 26 de mar. de 2015

There is an extensive thread in Answers about iPad mini backlight problems.Th screen stays black after a digitizer replacement.

jessabethany - 26 de mar. de 2015

After unplugging the battery place a guitar pick in-between the two connections.

While continuing to work on the iPad you may inadvertently cause the two connections to touch.

Michael Vovaris - 8 de jul. de 2015 Contestar

Yeah, you need to put the pick in between the connections so the battery doesn't touch the logic board connector and blow a fuse and make your backlight not turn on. You really don't want to have to solder the 2 connections together, especially if you don't know how, like me! I will use your comment's advice when working.

WolfyHD - 20 de jul. de 2017 Contestar

I put a piece of cellotape on the contact side of the connector and could happily forget about it while getting on with the rest of the repair.

Rory Filer - 28 de dic. de 2017 Contestar