Saltar al contenido principal

Introducción

Prerequisite only guide for removing the front panel assembly from an iPad Mini 3.

Partes

No se especificaron partes.

  1. Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket. Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket.
    • Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket.

  2. Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case. Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case.
    • Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. Lift the digitizer board up to free the last of the adhesive. Lift the digitizer board up to free the last of the adhesive.
    • Lift the digitizer board up to free the last of the adhesive.

  5. Lift and remove the front panel assembly from the iPad.
    • Lift and remove the front panel assembly from the iPad.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

Miembro Desde 05/02/15

168,673 Reputación

177 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

98 Miembros

8,966 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 152