Saltar al contenido principal

Introducción

Prereq only for adhesive strips.

  1. Remove the two 2.1 mm Phillips #00 Phillips screws securing the home button control board to the home button mounting bracket.
    • Remove the two 2.1 mm Phillips #00 Phillips screws securing the home button control board to the home button mounting bracket.

  2. Wedge the flat edge of a plastic opening tool in between the right end of the home button control board and the home button mounting bracket. Depress the plastic opening tool downwards to pry the adhesive securing the home button control board from the home button mounting bracket.
    • Wedge the flat edge of a plastic opening tool in between the right end of the home button control board and the home button mounting bracket.

    • Depress the plastic opening tool downwards to pry the adhesive securing the home button control board from the home button mounting bracket.

    • Repeat the procedure to release the adhesive underneath the left end of the home button control board.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. Lift and remove the home button control board up off the home button mounting bracket.
    • Lift and remove the home button control board up off the home button mounting bracket.

  5. Use the flat edge of a spudger to scrape the old adhesive off the bottom right corner of the front panel assembly. If necessary, gently peel the old adhesive with a pair of tweezers.
    • Use the flat edge of a spudger to scrape the old adhesive off the bottom right corner of the front panel assembly.

    • If necessary, gently peel the old adhesive with a pair of tweezers.

  6. Gently place the home button control board on top of the home button mounting bracket. Make sure the home button control board is lined up with the bottom of the home button mounting bracket.
    • Gently place the home button control board on top of the home button mounting bracket.

    • Make sure the home button control board is lined up with the bottom of the home button mounting bracket.

  7. Insert the two 2.1 mm Phillips #00 Phillips screws back into the home button control board to secure it against the home button mounting bracket.
    • Insert the two 2.1 mm Phillips #00 Phillips screws back into the home button control board to secure it against the home button mounting bracket.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 110