Saltar al contenido principal

iPad 3 4G Antenna Connectors Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. iPad 3 4G Antenna Connectors Replacement, Antenna Connectors: paso 1, imagen 1 de 1
    • Remove the seven screws securing the logic board to the rear aluminum panel.

    • Six 2.1mm Phillips #00

    • One 2.5mm Phillips #00

  2. iPad 3 4G Antenna Connectors Replacement: paso 2, imagen 1 de 1
    • Flip the logic board over, minding any cables that may get caught.

    • Using the tip of a spudger, remove the three antenna connectors from their sockets on the logic board.

    I know the middle connector goes to the left antenna. Where do the other two go?

    Anticept - Contestar

    Looking this pic, the left cable goes to the right antena and the right one to the middle antena (or whatever is there) under the front camera

    Maratech - Contestar

    Right antenna, left antenna, GPS

    Malcolm Stevens - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Brett Hartt

Miembro Desde 04/12/10

127,894 Reputación

143 Guías creadas

Equipo

iFixit Miembro de iFixit

Staff

135 Miembros

16,767 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 65