Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

iPad 2 GSM Headphone Jack & SIM Slot Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. iPad 2 GSM Headphone Jack & SIM Slot Replacement, Headphone Jack & SIM Slot: paso 1, imagen 1 de 2 iPad 2 GSM Headphone Jack & SIM Slot Replacement, Headphone Jack & SIM Slot: paso 1, imagen 2 de 2
    • Use the edge of a plastic opening tool to flip up the retaining flap on the headphone jack and front camera cable ZIF socket.

    • Be sure you are prying upward on the hinged retaining flap, not the socket itself.

    • Peel the headphone jack and front camera cable off the rear case.

  2. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 2, imagen 1 de 1
    • Pull the headphone jack and front camera ribbon cable straight out of its socket on the logic board.

  3. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 3, imagen 1 de 1
    • Remove the three 2 mm Phillips screws securing the SIM card slot to the rear panel.

  4. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 4, imagen 1 de 1
    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the top edge of the rear panel.

  5. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 5, imagen 1 de 1
    • Use a plastic opening tool to help pull the headphone jack out of its recess in the top of the rear panel.

    • Don't try to remove the assembly just yet, the ribbon cables are still connected.

  6. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 6, imagen 1 de 1
    • Peel the front camera and microphone cables off the rear panel.

  7. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 7, imagen 1 de 2 iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 7, imagen 2 de 2
    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use a plastic opening tool to disconnect the front camera cable from the microphone cable immediately below it.

  8. iPad 2 GSM Headphone Jack & SIM Slot Replacement: paso 8, imagen 1 de 1
    • Peel the front camera cable off the microphone cable.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

iFixit Miembro de iFixit

Staff

136 Miembros

16,562 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 233