Repara tus cosas Comunidad Tienda

iPad 2 CDMA Headphone Jack Assembly Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Introducción

Prereq only.

Qué necesitas

  1. iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: paso 1, imagen 1 de 3 iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: paso 1, imagen 2 de 3 iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: paso 1, imagen 3 de 3

    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

    Traducir

  2. iPad 2 CDMA Headphone Jack Assembly Replacement: paso 2, imagen 1 de 1

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

    Traducir

  4. iPad 2 CDMA Headphone Jack Assembly Replacement: paso 3, imagen 1 de 1

    • Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

    • Don't try to remove the assembly just yet.

    Traducir

  5. iPad 2 CDMA Headphone Jack Assembly Replacement: paso 4, imagen 1 de 1

    • Carefully peel the front camera and microphone cables off the rear panel.

    Traducir

  6. iPad 2 CDMA Headphone Jack Assembly Replacement: paso 5, imagen 1 de 2 iPad 2 CDMA Headphone Jack Assembly Replacement: paso 5, imagen 2 de 2

    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

    Traducir

  7. iPad 2 CDMA Headphone Jack Assembly Replacement: paso 6, imagen 1 de 1

    • Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 3 otros colaboradores

Phillip Takahashi

Miembro Desde 08/22/11

86,704 Reputación

87 Guías creadas

Insignias: 43

+ 40 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 421