Saltar al contenido principal

Introducción

This guide covers the disassembly of the iON SnapCam 1045 battery.

Partes

No se especificaron partes.

  1. iON SnapCam 1045 Wearable HD Video Camera Battery, Battery: paso 1, imagen 1 de 1
    • Detach the magnetic clip from the bottom of the camera.

    • The magnetic clip gets in the way of disassembly because it constantly spins and therefore a distraction so it is imperative to detach.

  2. iON SnapCam 1045 Wearable HD Video Camera Battery: paso 2, imagen 1 de 1
    • Use a spudger to gently detach the memory card and USB slot cover.

  3. iON SnapCam 1045 Wearable HD Video Camera Battery: paso 3, imagen 1 de 1
    • Use a Phillips #000 Screwdriver to loosen the 0.008 mm screw located between the USB and memory card slots.

    • This screw is really tiny and can easily fall off and get lost! Make use of a magnetic mat to hold it in place or better still put the magnetic clip to use for keeping the screw safe.

  4. iON SnapCam 1045 Wearable HD Video Camera Battery: paso 4, imagen 1 de 2 iON SnapCam 1045 Wearable HD Video Camera Battery: paso 4, imagen 2 de 2
    • Once again use the spudger to gently open the encasement.

    • The case is a little fragile and forceful entry could lead to damage of the plastic case. Thread carefully.

    • The Battery can be safely detached and replaced.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Olakunle

Miembro Desde 11/11/17

102 Reputación

1 Guía escrita

Equipo

IUPUI, Team S3-G3, Wilson Fall 2017 Miembro de IUPUI, Team S3-G3, Wilson Fall 2017

IUPUI-WILSON-F17S3G3

3 Miembros

3 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 4

Ultimos 30 días: 10

Todo El Tiempo: 529