Repara tus cosas

Derecho a reparar

Tienda

iMac Intel 27" EMC 2546 Heat Sink Replacement

Escrito Por: Andrew Optimus Goldheart (y 5 de otros participantes)
  • Comentarios: 0
  • Favoritos: 1

Dificultad

Moderado

Pasos

6

Tiempo Requerido

Sugerir un tiempo??

Secciones

1

Banderas

1

Prerequisite Only

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

Introducción

prerequisite for logic board, heat sink, and CPU

Herramientas

Comprar estas herramientas

Partes

No se especificaron partes.

  1. Remove the four 7.5 mm T8 screws from behind the GPU on the logic board. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.

    • Remove the four 7.5 mm T8 screws from behind the GPU on the logic board.

    • These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.

    Traducir

  2. Remove the bracket from behind the GPU heat sink.

    • Remove the bracket from behind the GPU heat sink.

    Traducir

  4. Remove four black stickers from the back of the CPU heat sink.

    • Remove four black stickers from the back of the CPU heat sink.

    Traducir

  5. Remove four 12.3 mm T10 screws from the back of the CPU heat sink.

    • Remove four 12.3 mm T10 screws from the back of the CPU heat sink.

    Traducir

  6. Remove the spring plate from behind the CPU heat sink. Lift and remove the backing plate from behind the CPU heat sink. The backing plate has two posts that fit into alignment holes in the logic board. Lift and remove the backing plate from behind the CPU heat sink. The backing plate has two posts that fit into alignment holes in the logic board.

    • Remove the spring plate from behind the CPU heat sink.

    • Lift and remove the backing plate from behind the CPU heat sink. The backing plate has two posts that fit into alignment holes in the logic board.

    Traducir

  7. Lift the heat sink up from the logic board. The CPU will most likely stick to the heat sink, so be careful about where you put it down. The CPU will most likely stick to the heat sink, so be careful about where you put it down.

    • Lift the heat sink up from the logic board.

    • The CPU will most likely stick to the heat sink, so be careful about where you put it down.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 5 otros colaboradores

Andrew Optimus Goldheart

Miembro Desde 17/10/09

468,354 Reputación

410 Guías creadas

Insignias: 44

+ 41 más insignias

Equipo

iFixit Miembro de iFixit

Community

134 Miembros

14,890 Guías creadas

0 comentarios

Agregar un comentario

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 154