Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Loosen the two Phillips screws securing the access door to your iMac.
-
Remove the access door.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following screws along the lower edge of your iMac:
-
Three 6 mm T8 Torx screws
-
One 8 mm T8 Torx screw
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To lift the front bezel off the iMac, simultaneously:
-
Use your thumbs to press in the RAM arms and hold the iMac down.
-
Use your index fingers to pull the small bridge of material on the front bezel toward yourself.
-
Pull the front bezel up with your index fingers.
-
Once the small bridge of material has cleared the RAM arms, lift the front bezel by its lower edge just enough to clear the bottom edge of the rear case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the front bezel off the rear case and rotate it away from the bottom edge of the iMac, minding the camera and microphone cables still attached to its upper edge.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the microphone cable.
-
Disconnect the camera cable by pulling its connector away from the socket on the camera board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel the two highlighted EMI shield tabs off the frame of the LCD.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two T6 Torx screws securing the display data cable to the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the black plastic tab attached to the display data cable connector to disconnect it from the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use your fingertips to pull both sides of the wide inverter cable connector out of its socket on the logic board.
-
De-route the inverter cable from its location next to the CPU fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the eight T8 Torx screws securing the display assembly to the rear case.
-
Cancelar: No complete esta guía.
4 personas más completaron esta guía.