Saltar al contenido principal

Introducción

Prereq only.

  1. Remove the strip of tape securing the GPU thermal sensor cable to the logic board.
    • Remove the strip of tape securing the GPU thermal sensor cable to the logic board.

  2. Remove the following three screws:
    • Remove the following three screws:

    • One 4.2 mm T10 Torx screw

    • Two 5 mm T8 Torx screws

  3. Grab the GPU thermal sensor cable connector and pull it straight up and out of its socket on the logic board.
    • Grab the GPU thermal sensor cable connector and pull it straight up and out of its socket on the logic board.

    • Do not pull the connector out by its cables.

  4. Lift the GPU heat sink slightly and pull the GPU board out of its socket on the logic board.
    • Lift the GPU heat sink slightly and pull the GPU board out of its socket on the logic board.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 185