Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
-
Adhiera una ventosa en los 2 angulos superiores del panel de vidrio.
-
Si sus ventosas no se pegan, limpie la superficie del vidrio y la goma de sus ventosas con un solvente liviano.
-
Insertar traducción aquí
-
-
-
Retira los ocho tornillos Torx T10 de 8 mm que sujetan la pantalla a la carcasa exterior.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tip of a spudger to push the SD board cable connector out of its socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single T8 Torx screw securing the SD board to the outer case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the free end of the SD board to clear the plastic optical drive fan body, then pull it away from the edge of the outer case case to clear the two mounting pins.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.