Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Partes

No se especificaron partes.

  1. Este paso está sin traducir. Ayuda a traducirlo

    Pull the optical drive thermal sensor connector straight away from its socket on the logic board.
    • Pull the optical drive thermal sensor connector straight away from its socket on the logic board.

  2. Este paso está sin traducir. Ayuda a traducirlo

    Remove the four 9 mm T10 Torx screws securing the optical drive to the outer case.
    • Remove the four 9 mm T10 Torx screws securing the optical drive to the outer case.

  3. Este paso está sin traducir. Ayuda a traducirlo

    Lift the inner edge of the optical drive and maneuver its connector past the frame attached to the logic board.
    • Lift the inner edge of the optical drive and maneuver its connector past the frame attached to the logic board.

    • Carefully pull the optical drive off its mounting pins on the edge of the outer case to gain clearance for disconnecting the optical drive cable.

  4. Este paso está sin traducir. Ayuda a traducirlo

    Use the flat end of a spudger to help disconnect the optical drive cable.
    • Use the flat end of a spudger to help disconnect the optical drive cable.

Linea de Meta

Una persona más ha completado esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 4

Todo El Tiempo: 1,604