Introducción

Remove the access door to replace RAM chips.

Partes

No se requieren partes.

  1. Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.
    • Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.

    • These screws will remain captive in the access door.

    • Remove the access door from your iMac.

    • During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.

    In order for the logic board to come out cleanly, one should remove the RAM at the end of this step.

    kevmacmills - Contestar

    Definitely! The author should make this as a step in the description (because not everyone reads Comments)

    finnik2d - Contestar

    Just did this procedure and the RAM must absolutely come out for the logic board to come free later.

    matt - Contestar

  2. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 11

Últimos 30 Días: 35

Todo El Tiempo: 7,984