Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Coloca el iMac con la pantalla hacia abajo sobre una superficie plana.
-
Afloja los tres tornillos Phillips que fijan el panel posterior al iMac.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the AirPort card slightly by its plastic tab and pull it straight away from its socket.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the flat end of a spudger between the body of the AirPort card and its antenna connector.
-
Push the spudger away from the AirPort card to disconnect the AirPort antenna.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 5.5 mm T6 Torx screws securing the AirPort bracket to the logic board.
-
Slightly lift the AirPort bracket off the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
De-route the AirPort antenna through the slot in the AirPort bracket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 5.5 mm T6 Torx screws securing the modem to the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry the modem straight up from its top edge to disconnect it from the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the modem cable connector straight away from the modem.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.