Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the hard drive thermal sensor by pulling the connector away from its socket parallel to the face of the hard drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.
-
Lift the hard drive off its lower pins and pull it out of the rear case, minding the cables that are still attached.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the flat end of a spudger into the gap between the SATA power connector and the hard drive.
-
Twist the spudger to separate the SATA power connector from the hard drive.
-
Pull the SATA power connector away from the hard drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the SATA data cable away from the hard drive.
-
Hard drive remains.
-