Introducción
Use this guide to replace your PRAM battery.
Qué necesitas
-
-
Lay the iMac display-side down on a flat surface.
-
Loosen the three Phillips screws securing the rear panel to the iMac.
-
-
-
Lift the AirPort card slightly by its plastic tab and pull it straight away from its socket.
-
-
-
-
Remove the two 5.5 mm T6 Torx screws securing the AirPort bracket to the logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
9 personas más completaron esta guía.