Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 8 mm brass Phillips screws securing the optical drive to the midplane.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the optical drive near the connector to separate it from the logic board.
-
Lift the free end of the optical drive slightly, then pull it away from the edge of the rear case to clear the two plastic positioning pins.
-
Lift the optical drive out of your iMac.
-