Introducción

You will be removing screws and pulling out your broken adapter in order to replace it with a new adapter.

Set the device with the adapter facing up.
  • Set the device with the adapter facing up.

  • Remove the following screws:

    • Two 10 mm Phillips #0

Agregar Comentario

Grip the plastic adapter case and pull upwards with a medium amount of force. You will have to twist forward a little so that the connections are visible.
  • Grip the plastic adapter case and pull upwards with a medium amount of force. You will have to twist forward a little so that the connections are visible.

  • The adapter will still be connected with wires, so make sure not to pull too hard.

Agregar Comentario

Remove the following screws: Four 7 mm Phillips #0 Lift out the two black plastic pieces that have come loose on either side of the circuit board, and set them aside.
  • Remove the following screws:

    • Four 7 mm Phillips #0

  • Lift out the two black plastic pieces that have come loose on either side of the circuit board, and set them aside.

Agregar Comentario

Carefully pry apart the bundle of white wires connected at the junction with the plastic opening tool. Do this slowly. Be careful not to damage the wires
  • Carefully pry apart the bundle of white wires connected at the junction with the plastic opening tool.

  • Do this slowly. Be careful not to damage the wires

  • Lift out the circuit board that has become loose.

Agregar Comentario

Pull out the adapter, and replace it with the new one.
  • Pull out the adapter, and replace it with the new one.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

John Kraemer

Miembro Desde 09/10/12

64 Reputación

9 Guías creadas

Equipo

Cal Poly, Team 3-21, Amido Fall 2012 Miembro de Cal Poly, Team 3-21, Amido Fall 2012

CPSU-AMIDO-F12S3G21

4 Miembros

9 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 2,079