Repara tus cosas Comunidad Tienda

iDeaUSA CT8 Motherboard Replacement

Introducción

In cases where the device is not responding, this guide will help you replace the motherboard.

Qué necesitas

  1. iDeaUSA CT8 Motherboard Replacement, Motherboard: paso 1, imagen 1 de 3 iDeaUSA CT8 Motherboard Replacement, Motherboard: paso 1, imagen 2 de 3 iDeaUSA CT8 Motherboard Replacement, Motherboard: paso 1, imagen 3 de 3

    • Place the tablet on a flat surface, facing upwards.

    • Starting from the portholes, use the plastic opening tools to remove the back cover of the tablet from the top half.

    • Being cautious of the wire connecting the speaker and the motherboard, place the front and back portion of the tablet close in proximity.

    Editar

  2. iDeaUSA CT8 Motherboard Replacement: paso 2, imagen 1 de 3 iDeaUSA CT8 Motherboard Replacement: paso 2, imagen 2 de 3 iDeaUSA CT8 Motherboard Replacement: paso 2, imagen 3 de 3

    • Locate the five 3.5 mm black screws on the motherboard.

    • Use the #00 Phillips screwdriver to remove the screws, place them in an appropriate location.

    Editar

  3. iDeaUSA CT8 Motherboard Replacement: paso 3, imagen 1 de 1

    • Carefully peel off the tape covering the circuit boards and blue ribbons. The tape can be disposed or saved for reuse.

    Editar

  5. iDeaUSA CT8 Motherboard Replacement: paso 4, imagen 1 de 3 iDeaUSA CT8 Motherboard Replacement: paso 4, imagen 2 de 3 iDeaUSA CT8 Motherboard Replacement: paso 4, imagen 3 de 3

    • After removing the tape, two blue ribbon wires can now be accessed. To disconnect, gently lift up the plastic ZIF tabs covering the wires.

    • Upon lifting the tab, the ribbons can now be safely pulled out of their connections.

    • To avoid breaking or damaging the plastic ZIF tabs, it is recommended to use tweezers.

    Editar

  6. iDeaUSA CT8 Motherboard Replacement: paso 5, imagen 1 de 1

    • Locate the two wires connecting the speaker to the motherboard.

    • Use a soldering iron to desolder the red and black wires from their sockets.

    • Solder the speaker wires back in place during reassembly.

    Editar

  7. iDeaUSA CT8 Motherboard Replacement: paso 6, imagen 1 de 2 iDeaUSA CT8 Motherboard Replacement: paso 6, imagen 2 de 2

    • Disconnect the wires connecting the battery to the motherboard.

    • Start from the sides and gently wiggle the connection out until it;s loose enough to pull.

    Editar

  8. iDeaUSA CT8 Motherboard Replacement: paso 7, imagen 1 de 2 iDeaUSA CT8 Motherboard Replacement: paso 7, imagen 2 de 2

    • Pull out and free the motherboard from its position.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 128