Repara tus cosas Comunidad Tienda

iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement

Introducción

Replacing this keyboard is easy and takes only a few minutes.

Qué necesitas

  1. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Battery: paso 1, imagen 1 de 1

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    Traducir

  2. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 2, imagen 1 de 1

    • Lift the battery out of the computer.

    Traducir

  3. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Keyboard: paso 3, imagen 1 de 1

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    Traducir

  5. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 4, imagen 1 de 1

    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

    Traducir

  6. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 5, imagen 1 de 1

    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

    Traducir

  7. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 6, imagen 1 de 1

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    Traducir

  8. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 7, imagen 1 de 1

    • Remove the four silver Phillips screws that secure the RAM shield.

    Traducir

  9. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 8, imagen 1 de 1

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    Traducir

  10. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: paso 9, imagen 1 de 1

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Documentos Adjuntos

Autor

con 6 otros colaboradores

iRobot

Miembro Desde 09/24/09

1 Reputación

636 Guías creadas

Insignias: 36

+ 33 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 12,221