Saltar al contenido principal

iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement, Rear Display Bezel: paso 1, imagen 1 de 1
    • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  2. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: paso 2, imagen 1 de 1
    • Use your thumbs to slightly separate the rear bezel from the front bezel.

    • It is helpful to hold the opposing corner of the display stationary to aid in flexing the rear bezel away from the display.

  3. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: paso 3, imagen 1 de 3 iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: paso 3, imagen 2 de 3 iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: paso 3, imagen 3 de 3
    • Insert the flat end of a spudger into the gap between the front and rear bezels.

    • Rotate your spudger until it is parallel to the front face of the display.

    • Run the spudger around the perimeter of the display to separate the rear bezel from its retaining clips.

  4. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: paso 4, imagen 1 de 1
    • Lift the rear bezel off the display.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 532