Saltar al contenido principal
Ayuda

PowerBook G4 Titanium DVI Optical Drive Removal Replacement

Sólo Prerrequisito

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

  • Autor: iRobot
  • Dificultad: Moderar

How to remove the combo or SuperDrive, including the attached modem and display inverter.

Herramientas
Partes Pertinentes

Paso 1 Optical Drive Removal  ¶ 

Disconnect and remove the indicated orange ribbon cable.

Paso 1 Optical Drive Removal  ¶ 

  • Disconnect and remove the indicated orange ribbon cable.

Paso 2  ¶ 

Disconnect the pink and white inverter cable from the inverter board.

Paso 2  ¶ 

  • Disconnect the pink and white inverter cable from the inverter board.

  • The display inverter has orange plastic shielding around it that looks similar to the tape used elsewhere within the computer. Do not remove the shielding from the inverter.

Paso 3  ¶ 

Remove the two silver T8 Torx screws from the black plastic bar.

Paso 3  ¶ 

  • Remove the two silver T8 Torx screws from the black plastic bar.

  • Lift the black plastic bar out.

  • Reassembly will be significantly easier if you reseat the hard drive before returning the black bar to its place.

Paso 4  ¶ 

Disconnect the two orange connectors from the logic board, removing tape as necessary.

Paso 4  ¶ 

  • Disconnect the two orange connectors from the logic board, removing tape as necessary.

Paso 5  ¶ 

Lift the drive up on the right side so that you can access and disconnect the modem cable and inverter cable.

Paso 5  ¶ 

  • Lift the drive up on the right side so that you can access and disconnect the modem cable and inverter cable.

Paso 6  ¶ 

Remove the drive by lifting the right edge up and out of the computer.

Paso 6  ¶ 

  • Remove the drive by lifting the right edge up and out of the computer.