Saltar al contenido principal
Ayuda

iPad 3 4G Logic Board Replacement

Replace the logic board in your iPad 3 4G.

  • Autor: Brett Hartt
  • Tiempo estimado: 1 hora
  • Dificultad: Muy difícil

Use this guide to replace the logic board.

Paso 1 Logic Board  ¶ 

Remove the following seven screws securing the logic board to the rear aluminum panel.

Paso 1 Logic Board  ¶ 

  • Remove the following seven screws securing the logic board to the rear aluminum panel.

  • Six 2.1mm Phillips #00

  • One of these screws, at the top of the logic board, is tucked beneath the headphone jack assembly cable. Take care to hold the cable out of the way while removing and replacing this screw.

  • One 2.5mm Phillips #00

Paso 2  ¶ 

Holding the logic board by the side nearest the dock connector, carefully pull the logic board toward the bottom of the iPad. Holding the logic board by the side nearest the dock connector, carefully pull the logic board toward the bottom of the iPad.

Paso 2  ¶ 

  • Holding the logic board by the side nearest the dock connector, carefully pull the logic board toward the bottom of the iPad.

Paso 3  ¶ 

Flip the logic board over, minding any cables that may get caught. Using the tip of a spudger, remove the three antenna connectors from their sockets on the logic board.

Paso 3  ¶ 

  • Flip the logic board over, minding any cables that may get caught.

  • Using the tip of a spudger, remove the three antenna connectors from their sockets on the logic board.