Saltar al contenido principal
Ayuda

iPad 3 4G LCD Replacement

Removing the LCD

  • Autor: Brett Hartt
  • Tiempo estimado: 1 hora
  • Dificultad: Moderar

The third generation iPad loses a lot of luster when its gorgeous retina display stops working. Use this guide to get your iPad back on its resolutionary feet.

Secciones
Herramientas

Paso 1 LCD  ¶ 

Using the tip of a spudger, peel back the piece of tape covering the LCD ribbon cable connector.

Paso 1 LCD  ¶ 

  • Using the tip of a spudger, peel back the piece of tape covering the LCD ribbon cable connector.

Paso 2  ¶ 

Flip up the retaining flap on the LCD ribbon cable ZIF connector. Using your fingers or a pair of tweezers, pull the LCD ribbon cable from its socket on the logic board. You may have to force restart the iPad by holding down the power button and home button for at least ten seconds until you see the Apple logo if the LCD screen doesn't power on after connecting the ZIF connector for the LCD screen when putting everything back together.

Paso 2  ¶ 

  • Flip up the retaining flap on the LCD ribbon cable ZIF connector.

  • Using your fingers or a pair of tweezers, pull the LCD ribbon cable from its socket on the logic board.

  • You may have to force restart the iPad by holding down the power button and home button for at least ten seconds until you see the Apple logo if the LCD screen doesn't power on after connecting the ZIF connector for the LCD screen when putting everything back together.

Paso 3  ¶ 

Without touching the front of the LCD, lift the LCD off the front panel.

Paso 3  ¶ 

  • Without touching the front of the LCD, lift the LCD off the front panel.