Saltar al contenido principal
Ayuda

Sony Clie PEG-T615C Thumb Dial Replacement

Necesita Mejores Imágenes

Necesita Mejores Imágenes

Mejores fotos mejorarán esta guía. Ayuda tomando, editando o subiendo nuevas imágenes!

How to replace a Sony Clie PEG-T615C thumb dial.

  • Autor: Rob
  • Tiempo estimado: 10 - 15 minutos
  • Dificultad: Moderar

The following guidelines will show the step-by-step procedure on how to remove and replace the Sony Clie thumb dial.

Paso 1 Thumb Dial  ¶ 

First, place the device with the screen side facing down. Remove the 2 screws from the thumb dial panel located on the upper right hand side.

Paso 1 Thumb Dial  ¶ 

  • First, place the device with the screen side facing down. Remove the 2 screws from the thumb dial panel located on the upper right hand side.

Paso 2  ¶ 

Remove the screw  directly above the thumb dial panel.

Paso 2  ¶ 

  • Remove the screw directly above the thumb dial panel.

Paso 3  ¶ 

Remove the screw from thumb dial panel on the right handed side of the device.

Paso 3  ¶ 

  • Remove the screw from thumb dial panel on the right handed side of the device.

Paso 4  ¶ 

Remove screw from lower right side of the device.

Paso 4  ¶ 

  • Remove screw from lower right side of the device.

Paso 5  ¶ 

Remove 1 screw from the lower left side of the device.

Paso 5  ¶ 

  • Remove 1 screw from the lower left side of the device.

Paso 6  ¶ 

On the bottom of the device, remove both the left and right screws.

Paso 6  ¶ 

  • On the bottom of the device, remove both the left and right screws.

Paso 7  ¶ 

Remove the thumb dial panel by sliding it away from the device.

Paso 7  ¶ 

  • Remove the thumb dial panel by sliding it away from the device.

Paso 8  ¶ 

Remove the back panel exposing the inside of the device.

Paso 8  ¶ 

  • Remove the back panel exposing the inside of the device.

Paso 9  ¶ 

Locate thumb dial on top right side of the board.

Paso 9  ¶ 

  • Locate thumb dial on top right side of the board.

Paso 10  ¶ 

Follow ribbon wire to locate where it plugs into the board.  The plug is a flat black square.

Paso 10  ¶ 

  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

Paso 11  ¶ 

Pull plug straight up to remove from board.

Paso 11  ¶ 

  • Pull plug straight up to remove from board.