Saltar al contenido principal
Ayuda

PowerBook G4 Titanium Mercury Hard Drive Replacement

Sólo Prerrequisito

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

  • Autor: iRobot
  • Dificultad: Fácil

How to remove the hard drive, along with its cable and bracket from your computer.

Paso 1 Hard Drive  ¶ 

Disconnect the hard drive ribbon from the logic board using a spudger or the tip of your finger.

Paso 1 Hard Drive  ¶ 

  • Disconnect the hard drive ribbon from the logic board using a spudger or the tip of your finger.

Paso 2  ¶ 

To free the hard drive, remove the two T8 Torx screws from the right wall of the battery housing.

Paso 2  ¶ 

  • To free the hard drive, remove the two T8 Torx screws from the right wall of the battery housing.

Paso 3  ¶ 

Remove the hard drive by gently grasping the orange ribbon cable and lifting the left edge up and out of the computer.

Paso 3  ¶ 

  • Remove the hard drive by gently grasping the orange ribbon cable and lifting the left edge up and out of the computer.

  • There are four rubber bumpers that fit over the hard drive screws. Ensure that these bumpers come out when you remove the hard drive.

Paso 4  ¶ 

Your laptop should look approximately like this.

Paso 4  ¶ 

  • Your laptop should look approximately like this.