Saltar al contenido principal
Ayuda

iPad 2 GSM Headphone Jack Assembly Replacement

Sólo Prerrequisito

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

Prerequisite only.

Prerequisite only.

Paso 1 Headphone Jack Assembly  ¶ 

Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself. Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

Paso 1 Headphone Jack Assembly  ¶ 

  • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

  • Be sure you are prying up on the hinged retaining flap, not the socket itself.

  • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

  • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

Paso 2  ¶ 

Remove the three 2 mm Phillips screws securing the SIM slot to the rear panel.

Paso 2  ¶ 

  • Remove the three 2 mm Phillips screws securing the SIM slot to the rear panel.

Paso 3  ¶ 

Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

Paso 3  ¶ 

  • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

Paso 4  ¶ 

Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

Paso 4  ¶ 

  • Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

  • Don't try to remove the assembly just yet.

Paso 5  ¶ 

Carefully peel the front camera and microphone cables off the rear panel.

Paso 5  ¶ 

  • Carefully peel the front camera and microphone cables off the rear panel.

Paso 6  ¶ 

Carefully remove the strip of tape covering the front camera cable connector. Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

Paso 6  ¶ 

  • Carefully remove the strip of tape covering the front camera cable connector.

  • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

Paso 7  ¶ 

Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.

Paso 7  ¶ 

  • Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.