Saltar al contenido principal
Ayuda

Scanner Head Replacement

Fotos de Acción

Fotos de Acción

Sé un héroe de acción! Esta guía necesita imágenes que demuestren mejor cómo llevar a cabo acciones específicas.

If your scanner is not working, it may need a new scanner head - this guide shows you how to replace it.

This guide will show you how to access and replace the scanner head on your HP PSC 2410 Photosmart All In One Printer.

Secciones
Herramientas

Paso 1 Detaching the Scanner Head  ¶ 

Detach the white ribbon wire from the scanner head by pulling gently at the connection. Detach the white ribbon wire from the scanner head by pulling gently at the connection.

Paso 1 Detaching the Scanner Head  ¶ 

  • Detach the white ribbon wire from the scanner head by pulling gently at the connection.

Paso 2 Removing the Scanner Head  ¶ 

Lift the gray drive belt from the black tab to disconnect the drive belt from the scanner head. Remove the scanner head from the scanner by gently rotating and then lifting.

Paso 2 Removing the Scanner Head  ¶ 

  • Lift the gray drive belt from the black tab to disconnect the drive belt from the scanner head.

  • Remove the scanner head from the scanner by gently rotating and then lifting.

Paso 3 Adding New Scanner Head  ¶ 

Place the new scanner head in the scanner tray by fastening the drive belt into the black tab. Make sure the tab on the outer portion of the gray drive belt is fastened.

Paso 3 Adding New Scanner Head  ¶ 

  • Place the new scanner head in the scanner tray by fastening the drive belt into the black tab.

  • Make sure the tab on the outer portion of the gray drive belt is fastened.

  • Once the drive belt is secured, rotate the scanner head back into position.

  • Re-attach the white ribbon wire to the connection from Step 10.