Saltar al contenido principal
Ayuda

HP PSC 2410 Photosmart All In One Printer Printer Carriage Replacement

Fotos de Acción

Fotos de Acción

Sé un héroe de acción! Esta guía necesita imágenes que demuestren mejor cómo llevar a cabo acciones específicas.

Texto Confuso

Texto Confuso

Parte del texto de esta guía es confuso, duplicado o fuera de tema. Mejorala!

Bordeador de Pasos

Bordeador de Pasos

Esta guía tiene pasos innecesarios. Recórtalos para que sean más conciso!

With this guide you will remove the old printer carriage and replace it with a new one.

  • Autor: Cody Long
  • Tiempo estimado: 10 - 20 minutos
  • Dificultad: Moderar

In order to perform this installation see the guide for Removing Scanner Tray. After the scanner tray is removed the steps to replace the printer carriage are simple.

Secciones
Herramientas
Partes Pertinentes

Paso 1 Printer Carriage  ¶ 

Remove printer carriage cover by unscrewing 4 black coarse thread T-10 torx screws marked with red circles.

Paso 1 Printer Carriage  ¶ 

  • Remove printer carriage cover by unscrewing 4 black coarse thread T-10 torx screws marked with red circles.

Paso 2  ¶ 

Depress the plastic tabs marked in yellow to release the cover from the sides.

Paso 2  ¶ 

  • Depress the plastic tabs marked in yellow to release the cover from the sides.

Paso 3  ¶ 

Slide the printer carriage to the center of the printer. Disconnect the printer carriage from the rod one side at a a time by pulling upward. Unhooking the printer carriage is difficult and will require a fair amount of force. The plastic strip that guides the carriage is fragile and can be broken easily.

Paso 3  ¶ 

  • Slide the printer carriage to the center of the printer. Disconnect the printer carriage from the rod one side at a a time by pulling upward.

  • Unhooking the printer carriage is difficult and will require a fair amount of force.

  • The plastic strip that guides the carriage is fragile and can be broken easily.

  • Pull carriage up from the bottom.

Paso 4  ¶ 

Pull on the two white wire strips on the printer carriage to remove. Wire strips are fragile. Pull from connection to carriage and not the ribbon cable itself.

Paso 4  ¶ 

  • Pull on the two white wire strips on the printer carriage to remove.

  • Wire strips are fragile. Pull from connection to carriage and not the ribbon cable itself.

Paso 5  ¶ 

Place new printer carriage on the carriage rod one side at a time. For proper reassembly, place the printer carriage’s black lip beneath the overhanging metal flap at the back of the printer. For proper reassembly, place the printer carriage’s black lip beneath the overhanging metal flap at the back of the printer.

Paso 5  ¶ 

  • Place new printer carriage on the carriage rod one side at a time.

  • For proper reassembly, place the printer carriage’s black lip beneath the overhanging metal flap at the back of the printer.